|
troutcatcher
P Plater
18 Posts
 |
 Posted - 06 Jun 2010 : 2:01:08 PM
|
|
Hi I am new to the site just registered today. I have a series I vn in my jet boat which is giving me some problems. I have done over 80 hours and have had to replace the igniter, and 4 crank angle sensors so thought it was time to solve the problem. I seem to be getting 12 volts across two terminals on the sensor which I think causes the problem. It starts fine when cold and if you do about 15 minutes boating and stop the engine it won't restart until you pour cold water on the sensor. When it wont start the sensor appears to be quite hot. Hoping some one can help Ian
|
|
Report to Moderator |
|
Topic Locked
| Join the Forum to Rate this Topic at: 