Not registered? Then you're not seeing all there is to see. Do you want to contribute? Register now by clicking HERE!
www.VNCommodore.com Support Site - Forums Page © 2005 - 2023
    Forums Page 

 
Main Menu

Start Page  
Forums  
Register  
Recipe Book  
Active Topics  
Active Polls  
Forum Search  
Online Auctions  
Online Classifieds  
FAQ  
Greeting Cards  
Guestbook  
Disclaimer  
Contact Us  
Links  
Username:

Password:

Save Password
Forgot your Password?

 
www.VNCommodore.com Support Forums
 All Forums
 General Area
 Technical Modifications
 Vr steering rack into vn k frame ???
 New Topic  Topic Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  
  Current Topic Rating: Total Rating: 0 | Join the Forum to Rate this Topic at: www.VNCommodore.com Support Forums  

bt1aero
P Plater


car-burningrubber

48 Posts

Male

Posted - 03 Jan 2011 :  11:03:09 PM  Show Profile Send bt1aero a Private Message
 
Hi gang as you may know I'm doing the conversion from vn to vr hit a snag today the vr steering don't mate up to vn but got me thinking can I use the vr rack and change the tie rods and rod ends over with the vr ends ie use vn ends on vr rack it's the only thing I've come up with anyone think this may work
Report to Moderator

Mechknight73
National Driver


robot-robot14

1001 Posts

Male

Posted - 03 Jan 2011 :  11:46:36 PM  Show Profile Send Mechknight73 a Private Message
 
The main thing that changed from VP to VR was the geometry of the struts. The struts on the VR-VS are set backwards further than the VN/VP. In theory the VN ends should work. Have you measured the bolt pattern on the rack? It's not like Holden to change something unless it's an improvement, but often those improvements are of the "bolt on" variety
Report to Moderator Go to Top of Page

bt1aero
P Plater


car-burningrubber

48 Posts

Male

Posted - 04 Jan 2011 :  08:42:36 AM  Show Profile Send bt1aero a Private Message
 
I've not checked the lenth but the rack looks like it will bolt into the frame I'm going to strip the vn unit out and will line them up to see what needs swapping will post my out come later today when I find out what's fits lol
Report to Moderator Go to Top of Page

bt1aero
P Plater


car-burningrubber

48 Posts

Male

Posted - 18 Jan 2011 :  8:20:31 PM  Show Profile Send bt1aero a Private Message
 
Well been some time from my last post but vr rack is in with vn tie rods and ends in this now gives me speed sencer and the right shaft to meet up with the vr firewall and steering shaft it's all bolt in job
Report to Moderator Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Topic Locked
 Printer Friendly
Jump To:
www.VNCommodore.com Support Forums © 2005 - 2023 Go To Top Of Page  
This page shown in 0.19 seconds.   Snitz Forums 2000
Do not Click Here
   
 


Currently 30 user(s) online
 
Copyright © 2005 - 2023 by: Greening Computer Services